Arthur_Martin AGH6343LOX Manuale Utente Scaricare il pdf (Pagina 12)

Make sure that the gas supply

pressure of the appliance obeys

the recommended values. The

adjustable connection is fixed to

the comprehensive ramp by

means of a threaded nut G 1/2".

Screw the parts without force,

adjust the connection in the

necessary direction and tighten

everything.

A B C

A.

End of shaft with nut

B.

Washer supplied with the appliance

C.

Elbow supplied with the appliance

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end).

"Flexible" connection with mechanical

end:

• Natural gas: connection carry out with

a flexible pipe with mechanical end

which is screwed directly on the elbow

finishing the slope of the appliance.

• Butane/Propane: use a flexible tube,

equipped with it's collars if it is worth

visiting over all it's length and if the

appliance runs only on butane. If the

appliance runs on Propane, use a

flexible pipe with suitable metal end.

Flexible nonmetal pipes connection:

If it is possible to easily control the

connection in its full area, you can use a

flexible pipe. Tightly attach the flexible pipe

by clamps.

Liquid gas

Use the rubber pipe holder for liquid gas.

Always engage the gasket. Then continue

with the gas connection.

The flexible pipe is prepared for apply

when:

• it can not get hot more than room

temperature, higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting

edges or corners;

• it can be easily examined in order to

make sure its condition.

The control of preservation of the flexible

pipe consists in checking that:

• it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length;

• the material is not hardened, but shows

its correct elasticity;

• the fastening clamps are not rusted;

• expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

WARNING! When installation is

complete, make sure that the

seal of each pipe fitting is

correct. Use a soapy solution,

not a flame!

Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in "Technical

Information" chapter).

4. Assemble the parts, follow the same

procedure backwards.

5. Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this plate in the package supplied with

the appliance.

If the supply gas pressure is changeable or

different from the necessary pressure, you

must fit an applicable pressure adjuster on

the gas supply pipe.

12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Commenti su questo manuale

Nessun commento